HA03 REPLACEMENT CERAMIC KIT FOR MIST MAKER (9 PCS)
- Comes with replacement ceramic disc (membrane) &
key tool for installation
- Black rubber edge around disc is for packaging only,
remove it before installing
- The diameter of each ceramic disc is 2cm.
After operation the mist unit for some time, you may notice a decrease in the amount of mist produced or it may stop working altogether. At that time, you should either clean or replace the ceramic disc.
Follow the instruction below
to change the disc:
2. Using the replacement disc/key tool, insert the key into the winding ring and turn counter clockwise.
3. Remove the filler piece(washer) and ceramic disc. IMPORTANT, note that there is a front and back of the ceramic. Be sure to re-install with the correct side(No black color ring side) facing up.
4. Clean mineral deposits on the ceramic with a soft cloth and re-install it or proceed to install a new ceramic disk in the reverse order of the above.
5. The inside area of the mist maker cavity must be completely dry before the parts are installed.
